Dry powder material for use in immobilizing petroleum-based liquids on land, including fuels solvents, paints, etc. The product is suitable to bond or congeal a spill to slow or stop the spread of the liquid.

RECOMMENDED APPLICATION RATE:

The product is ideally suited for spill clean-ups, transforming liquids and fluids to a removable solid, with minimal volumetric increase. The amount of product to be used depends on the desired results (i.e., from congealing to solidification). The application rate may vary with the viscosity of the liquid being picked up. To fully solidify the liquid normally requires one (1) pound of A650 to ten (10) pounds of spilled liquid. Test a small sample for predictable rate of usage. Pick up ratio and speed of solidification will vary with type of liquid being bonded, amount of volatiles remaining, temperatures and the viscosity of the liquid.

SPECIFIC WEIGHT:  21 lbs. per cubic foot

WEIGHT BY VOLUME:  One (1) pound equals (82) cubic inches 

SPECIFIC GRAVITY:  .94 

FLASH POINT:  N/A 

PH SPECIFICATIONS:  Neutral (6.5) to (7)

TOXICITY:  This product is non-toxic, non-hazardous, non-corrosive; see Material Safety Data Sheet.

Petroleum-based liquids and solvents. Not suitable for some acids. Before application, user should test applicability of product in small samples of spilled liquid to determine the suitability and/or application rate needed.

STORAGE SPECIFICATIONS:  Keep free of contamination.

VOLATILITY BEFORE USE:  None

VOLATILITY AFTER USE:  Varies with the flammability of the liquid being bonded.

The product has been field tested and demonstrated on various flammable and hazardous liquid chemicals. Information is available upon request.

The product may be packaged in assorted sizes and containers depending on the desire or need of the user. Standard packaging is 40 pound drums.

Extreme caution must be exercised when handling, storing and disposing of solidified or gelled hazardous materials. COMPLIANCE: Solidified or gelled materials must be disposed of in accordance with federal, state and local laws and regulations. The user is solely responsible for compliance with disposal laws and regulations; the manufacturer or seller assumes no responsibility for the proper or improper disposal or solidified or gelled materials.

Leaks and spills on land and structural surfaces: Spread evenly on the surface of a spill, and allow solidification process to occur, remove as conditions permit. Containerized wastes can also be solidified. Mechanical mixing is required to achieve best results.